Need metal roof installation in Ellis? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Ellis install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Ellis is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Ellis metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
The order we work in, and why each step matters more than it looks.
We measure the roof on site, count the valleys, hips and penetrations, and bring the color chart so you can hold it up against your siding.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Ridge caps, closures, drip edge and gable trim finish the roof and keep wind driven rain and wasps out from under the panels.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Ellis homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Sometimes. If the decking is sound and there is only one layer of shingles, a Ellis metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
Most Ellis metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Installed properly over sound decking, a metal roof should give a Ellis home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Real feedback from homeowners we have worked for.
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Second roof they have done for our family. My sister used them first and would not hear of me calling anybody else."